Pairing an Alfred Door Lock – K4Connect Support Center

❗️DO NOT pair the lock with the Alfred app. Discard the included consumer guide and follow the below pairing instructions

Connecting the Alfred Lock to a K4 Smart Home system consists of two steps:

Both operations are done in the K4Ops application:

Z-Wave pairing to the K4 controller (for resident control)
Bluetooth pairing to K4Ops (for staff access)

Z-Wave Pairing

Before beginning:

Ensure the device battery is charged to 100%
- By law, Alfred ships their door lock batteries at 70% or lower and they recommend fully charging the battery before use
Make sure the Latest K4Ops has been installed
Make sure the optional Z-Wave module is installed in the lock

In the K4Ops App:

Go the “Install a Room” section of K4Ops
Choose the correct community and room. If the lock is already in the room model, skip to step 4
If the lock does not appear in the room model:
1. Click the + button > Add Device
2. Choose Group: Locks > Device: Alfred DB2-B Lock > select the room the device is in
3. Give the device a name such as "Front Door"
4. Click "Add Device" to continue
Click on the Lock in the device list and follow the on-screen instructions to pair the device
Skip the Unpair step by clicking the "Next" button
On the device:
1. Enter the default master code of ** + 12345678 + # to enter setup mode.
  - You'll be prompted to update the master code to something more unique - make sure to document the new code somewhere to remember it
2. Press 8 to enter Network Settings
3. Press 1 to start pairing

Once the device is paired, click Next and follow the remaining on-screen steps to test all devices in the room and save the changes to the controller.

Other door lock options can be found here in the programming guide.

Note: If you're adding the lock to a room that has already been installed, you can call K4 Support at (855) 876-9673 for remote pairing to avoid repeating the tests for all devices in the room

Bluetooth Pairing

Before beginning Bluetooth pairing:

Make sure the Latest K4Ops has been installed and Bluetooth is turned on for the K4Ops app in your device settings
Be within 3 ft. of the device

In the K4Ops App:

Go to the Lock Manager section of K4Ops
Choose the correct community
Click the + button > Register Lock
Select the lock by serial number in the list of Nearby Locks
Enter a unique name for the lock. (ex. “Room 101 Front Door”)
Wake the device by tapping anywhere on the keypad. The keypad will illuminate when the device is awake
In the K4Ops app, enter the master code (numbers only, without the ** and #) and click Save
Return to Lock Manager and select the room you just registered and make sure you can remotely lock and unlock the door successfully. If you're having trouble with this step, try closing the K4Ops app and relaunching to try again.

Lock Admin users can grant other users access by clicking on the + button and selecting “Manage Users”